Cleaning Instructions; Dispenser - Cornelius Remcor TJ200 Operator's Manual

WARNING: DISCONNECT POWER BEFORE CLEANING! Do not use metal scrapers, sharp
objects or abrasives on the ice storage hopper, top cover and the agitator disk, as damage
may result. Do not use solvents or other cleaning agents, as they may attack the plastic
material.

DISPENSER

1. Clean the ice dispenser interior at least once a month.
2. Remove the agitator bolt and lift off the agitator and the agitator disk. Wash with a mild detergent solution
and rinse them thoroughly to remove all traces of detergent.
3. Carefully remove, wash and rinse all internal hopper components.
4. wash down the inside of the hopper and top cover with a mild detergent solution and rinse thoroughly to
remove all traces of detergent.
5. Replace the agitator and other components.
6. Sanitize the inside of the hopper and agitator with a solution of 1 ounce of household bleach in 2 gallons of
water. (200 PPM)
7. Remove Ice Chute cover as follows:
A. Flex sides outward to disengage lower pins.
B. Lift Ice Chute cover to disengage upper pins.
C. Lower Ice Chute cover down out of unit. Note: it may be helpful to twist cover slightly.
8. With brush provided clean the inside of the ice chute and ice chute cover with a mild detergent solution and
rinse thoroughly to remove all traces of detergent.
9. Reverse steps above to reassemble ice chute.
10. Sanitize as described in Step 6.
90683

CLEANING INSTRUCTIONS

6