The following dispenser maintenance should be performed at the intervals indicated: DAILY (or as required) Remove foreign material from vending area drip tray to prevent drain blockage. WEEKLY (or as required) Clean vending area. Check for proper water drainage from the vending area drip tray. MONTHLY Clean and sanitize the hopper interior and beverage system, if applicable (see CLEANING INSTRUCTIONS).
DISPENSER 1. CLEANING EXTERIOR SURFACES Important: Perform the following daily. Remove the cup rest from drip tray. Wash the drip tray with soap solution. Rinse with clean water and allow solution to run down the drain. Wash cup rest with soap solution and rinse in clean water. Install the cup rest into the drip tray. Clean all exterior surfaces with soap solution and rinse in clean water.
BEVERAGE SYSTEM (IF APPLICABLE) WARNING: Disconnect Power Before Cleaning! Do not use metal scrapers, sharp objects or abrasives on the ice storage hopper, top cover and the agitator disk, as damage may result. Do not use solvents or other cleaning agents, as they may attack the plastic material. Soap solution - Use a mixture of mild detergent and warm (100 F) potable water.
Page 6
Discard the tank of sanitizing solution and reconnect the product (syrup or pre-mix) tanks. Oper- ate the valves until all sanitizer has been flushed from the system and only product (syrup or pre- mix) is flowing. Sanitize syrup lines, B-I-B Systems Remove all the quick disconnects from all the B-I-B containers.
IMPORTANT: Only qualified personnel should service internal components or electrical wiring. WARNING: If repairs are to be made to a product system, remove quick disconnects from the applicable product tank, then relieve the system pressure before proceeding. If repairs are to be made to the CO system pressure before proceeding.
Trouble BEVERAGES NOT SWEET ENOUGH. BEVERAGES NOT COLD (UNITS WITH BUILT-IN COLD PLATE). Contact your local syrup or beverage equipment distributor for additional information and troubleshoot- ing of beverage system. 620911101 Probable Cause Empty syrup tank. Faucet brix requires adjusting. Unit standing with no ice in hopper –...
DRAIN Item Part No. 70750 53170 51280 53293 Contact Factory FIGURE 4. DRAIN FOR Z STYLE UNITS Name Hose Clamp Drain Tube Elbow Coupler Lower Front Panel 620911101...
IMI Cornelius Inc. warrants that all equipment and parts are free from defects in material and workman- ship under normal use and service. For a copy of the warranty applicable to your Cornelius, Remcor or Wilshire product, in your country, please write, fax or telephone the IMI Cornelius office nearest you.