Gate Restrictor Plate; Adjustment; Figure 2. Gate Restrictor Plate - Cornelius Remcor TJ200 Operator's Manual

GATE RESTRICTOR PLATE

CAUTION: Disconnect power to dispenser before installing, removing or adjusting
restrictor
INSTALL PLATE ON
STUDS AS SHOWN

ADJUSTMENT

This dispenser is provided with a gate restrictor plate, installed in its highest position.
This plate adjusts the rate of ice flow from the dispenser. In applications using buckets, carafes or other large
containers, the plate may be removed entirely for maximum ice flow. For glasses and cups, the plate may be
adjusted downward to reduce the flow of ice. The best position depends on the type of ice being used and the
size container, and must be found by trial and error. Adjustment is made by loosening the upper two ice chute
retaining nuts, sliding the restrictor plate to the desired position and re-tightening the nuts.
If the dispenser fail to dispense the ice when operated, check that the hopper has ice in it and that power is be-
ing supplied to the unit. If the problem persists, check the following.
1. Determine if the agitator is rotating (check for the sound of ice movement in the hopper).
2. Observe whether the gate is operating.
90683

FIGURE 2. GATE RESTRICTOR PLATE

8