Cleaning Instructions; Dispenser; Col D Plate - Cornelius TJ200 Operator's Manual

Ice/beverage dispensers

Hide thumbs Also See for TJ200:

Operator's manual (20 pages)

Table Of Contents

Table of Contents

WARNING: DISCONNECT POWER BEFORE CLEANING! Do not use metal scrapers, sharp

objects or abrasives on the ice storage hopper, top cover and the agitator disk, as damage

may result. Do not use solvents or other cleaning agents, as they may attack the plastic

material.

DISPENSER

1. Clean the ice dispenser interior at least once a month.

2. Remove the agitator bolt and lift off the agitator and the agitator disk, taking care not to lose the shaft key.

Wash with a mild detergent solution and rinse them thoroughly to remove all traces of detergent.

3. Carefully remove, wash and rinse all internal hopper components.

4. Wash down the inside of the hopper and top cover with a mild detergent solution and rinse thoroughly to

remove all traces of detergent.

5. Replace the agitator and other components.

6. Sanitize the inside of the hopper and agitator with a solution of 1 ounce of household bleach in 2 gallons of

water. (200 PPM)

7. Remove Ice Chute cover as follows:

Flex sides outward to disengage lower pins.

Lift Ice Chute cover to disengage upper pins.

Lower Ice Chute cover down out of unit. Note: it may be helpful to twist cover slightly.

8. With brush provided clean the inside of the ice chute and ice chute cover with a mild detergent solution and

rinse thoroughly to remove all traces of detergent.

9. Reverse steps above to reassemble ice chute.

10. Sanitize as described in Step 6.

COL D PLATE

1. Carefuly remove the lower front panel of the ice dispenser. On "BC models with 19 x 28 cold plate, remove

the beverage faucet panel.

2. Remove cold plate cover by lifting slightly in front and slide forward. On "BC" models with 19 x 28 cold

plate, the cover is two (2) pieces. Remove only the front cover.

3. Wash down the inside of the cold plate and cover with mild detergent solution and rinse. A small long han-

dled brush wil be found helpful in reaching the corners.

4. Replace the cover, taking care that it is securely positioned in cold plate tray.

5. Replace and lower front panel, carefully feeding the tube and wires into the cabinet. Be sure not to pinch

any tubing or wires between the panel and cabinet.

BEVERAGE SYSTEM CLEANING AND SANITIZING INSTRUCTIONS

1. Prepare the following cleaning, rinsing and sanitizing solutions using a clean, empty figal (5 gallon syrup

tank) for each solution.

91678