Basic Operation; Adjusting Temperature - Rinnai V2532FFU Series Operation & Installation Manual

1

Adjusting Temperature

The outlet water temperature of the Rinnai
Water Heater can only be adjusted by
the user using the remote controller(s).
To adjust the setpoint temperature of
the Rinnai Water Heater, all hot water
taps must be closed, and all circulating
pumps turned off (where applicable). The
temperature displayed on this remote
controller will also be displayed on all
other remote controller(s).
TEMPERATURE CANNOT BE ADJUST-
ED EXCEPT BETWEEN 98
O
110 F WHEN ANY HOT WATER
TAP IS OPEN.
2
To take control of the Rinnai Water Heater
all hot water taps must be closed. Press
the "Priority button" on the Controller you
want to set the temperature with, and
the green "Priority" indicator light will
glow. This indicates that the Rinnai Water
Heater is ready to supply hot water at
the set temperature as soon as a tap is
opened.
Note: Rinnai Water Heater will not provide
hot water instantly at the hot water
fi xtures. Any cold water existing in the hot
water lines must be purged fi rst.
CHECK WATER TEMPERA-
TURE BEFORE ENTERING
SHOWER OR BATH.
Rinnai America
B A S I C O P E R A T I O N
O
F AND
9
3
Simply press the
until the required temperature is
displayed on the Digital Monitor.
There is a hot water scald potential if
the thermostat is set to high.
CHECK LOCAL CODES
FOR THE MAXIMUM
WATER TEMPERATURE
SETTING ALLOWED
WHEN USED IN
NURSING HOMES,
SCHOOL, DAY CARE
CENTERS, AND ALL
OTHER PUBLIC
APPLICATIONS.
4
ON! ON!
HOT HOT
To operate the Rinnai Water Heater
simply turn any hot water tap on.
This will automatically light the burner
providing hot water at the preset
temperature. If the optional remote
controller(s) have been installed, the
red "IN USE" indicator will glow on
all remote controller(s).
or button
COLD COLD
FF Models