Lighting The Unit - Rinnai V2532FFU Series Operation & Installation Manual

I N S TA L L E R ' S I N S TA L L AT I O N I N S T R U C T I O N S
WARNING: If you do not follow these instructions exactly, a fi re or explosion
may result causing property damage, personal injury or loss of life.
1) This water heater does not have a pilot. It is equipped with a direct ignition
device which automatically lights the burner. DO NOT TRY TO LIGHT THE
BURNER BY HAND.
2) Before operating the Rinnai Water Heater smell all around the unit for gas.
Be sure to smell near the ground as leaking gas may settle there.
3) Turn the manual gas control valve on.
4) Turn on any hot water tap. The Rinnai Water Heater should light and begin
heating your water.
1) DO NOT ATTEMPT TO LIGHT BY HAND.
2) Turn off the electrical power to the unit.
3) Turn off the manual gas control.
4) Wait 5 minutes, if you smell gas, go to a neighbor's house and call the gas
company or the fi re department. If you do not smell gas, go to the next step.
5) Turn the manual gas control valve on.
6) Turn the electrical power to the unit on.
7) Turn on any hot water tap.
8) If the unit still fails to light, turn off the electricity and gas to the unit and call
Rinnai 1-800-621-9419.
Rinnai America

Lighting the Unit

STOP!! READ THE SAFETY ISSUES ON PAGES 8
If the Rinnai Water Heater fails to light
43
FF Models