Operation Accessing An Frg Node - Yaesu VX-3E Operating Manual

I C
NTERNET
FRG "F
17. When you have programmed a label that is less than 6 charac-
ters, press the [ TXPO ] key to confirm the label.
18. Repeat steps 3 through 17 to store other access codes, if so de-
sired.
19. Press the PTT switch to save the settings and exit to normal operation.
O A
PERATION CCESSING AN
1. Press and hold in the [ TXPO ] key for one second to enter the Set mode again.
2. Rotate the DIAL knob to select Set Mode Item 39: INT MD.
Note: Do not forget to pull the DIAL knob to rotate the DIAL
knob.
3. Press the [ TXPO ] key to enable adjustment of this Set Mode
Item.
4. Rotate the DIAL knob to set this Set Mode Item to "FRG" (thus
activating the "Other Internet Link System" mode).
5. Press the PTT switch to save the new settings.
6. Press the [ ] key momentarily to activate the Internet Connec-
tion feature. The " " icon will appear in the upper right corner
of the display.
7. Rotate the DIAL knob while pressing the [ ] key to select the
Internet Memory register number ("F 0" - "F63") correspond-
ing to the Internet link repeater to which you wish to establish an
Internet link, then press the PTT switch momentarily to lock in
the selected access number.
8. Once the Internet Connection feature is activated per step 7 above, you may now press
the [ ] key, while you are transmitting, to send out the selected DTMF string (to
establish the link to the desired Internet-link mode).
9. To return to the WIRES™ SRG mode, repeat steps 1 - 5 above, selecting "SRG" in
step 4.
84
ONNECTION FEATURE
RIENDLY
FRG N
R G
ADIO ROUP
ODE
VX-3R/E O
"
MODE
M
PERATING ANUAL