Cw Learning Feature - Yaesu VX-3E Operating Manual

CW L
EARNING
The VX-3R/E provides a CW learning function, which sends the designated Morse Code
via the sidetone (heard in the speaker) to help your CW learning.
1. Press and hold in the [ TXPO ] key for one second to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 20: CWLRNG.
Note: Do not forget to pull the DIAL knob to rotate the DIAL
knob.
3. Press the [ TXPO ] key momentarily to enable adjustment of this
Set Mode Item.
4. Press the [ MODE ] key to select the Training mode (displayed in fine print at the upper
edge of the LCD):
Sends the Alphabet characters
A:
A_r: Sends the Alphabet characters (move to next character au-
tomatically)
n: Sends the Numeric characters
n_r: Sends the Numeric characters (move to next character automatically)
Sends the Symbol characters
S:
S_r: Sends the Symbol characters (move to next character automatically)
5. Rotate the DIAL knob to select the Morse speed. You may select
the units of the code speed between "CPM (characters per minute)"
and "WPM (Words per minute)" by pressing the [ V/M ] key.
6. Press the [ BAND ] key to switch the flashing of the LED (white)
on and off; a "dot" by the CW speed indicates that the LED is on.
7. Press the [ HM/RV ] key to change the display on the right. Rotate
the DIAL knob to select the CW code which you want to learn
and press the [ V/M ] key select the repetition time (1 - 9) of the
sending.
8. Press the [ F/W ] key to begin generating the selected code char-
acters the designated number of times (Only the speaker CW
sidetone is heard, the radio does not transmit).
9. If one of the "r" modes is selected in step 4 above, you may change the direction of the
character rotation by tuning the DIAL knob.
10. You may adjust the CW sidetone audio level by rotating the DIAL knob while pressing
and holding the [ VOL ] key.
11. If one of the "r" modes is not selected in step 4 above, press the [ F/W ] key to send
again, or select another code by rotating the DIAL knob and press the [ F/W ] key to
begin generation.
If one of the "r" modes is selected in step 4 above, press the [ F/W ] key to stop the CW
generation.
12. To stop the CW generation, press the [ F/W ] key again.
13. To disable the CW learning feature, press the PTT switch.
88
F
EATURE
Repetition Time
VX-3R/E O
PERATING
CW Code
M
ANUAL