Memory Scanning - Yaesu VX-3E Operating Manual

S
CANNING
Memory scanning is also easy to initiate:
1. Set the radio to the Memory mode by pressing the [ V/M ] key, if necessary.
2. Press and hold in the [ BAND ] key for one second, and rotate the
DIAL knob while holding in the [ BAND ] key to select the de-
sired Memory Scan mode. Available selections are ALL CH,
TAG1, TAG2, BAND, and PMS-X.
ALL CH: The scanner sweeps all Memory channels.
TAG1: The scanner sweeps only those Memory channels with the same first digit of
the alpha/numeric tag as the first channel on which scanning started.
TAG2: The scanner sweeps only those Memory channels with the same first and
second digits of the alpha/numeric tag as the first channel on which scanning
started.
BAND: The scanner sweeps only those Memory channels which are memorized on
the same operating band as the first channel on which scanning started.
PMS-X: The scanner will sweep frequencies within the currently-selected PMS fre-
quency pair. See page 61 for details.
Note: Do not forget to pull the DIAL knob to rotate the DIAL knob.
3. Release the [ BAND ] key to initiate scanning.
4. As with VFO scanning, the scanner will halt on any signal encountered that is strong
enough to open the squelch; it will then resume scanning accord-
ing to the Scan-Resume mode set previously. When there are no
memory channels corresponding to the selected Memory Scan
mode, the "MS ERR" notation will appear on the display.
5. To cancel scanning, press the PTT switch or [ V/M ] key.
58
M S
EMORY CANNING
VX-3R/E O
PERATING
M
ANUAL