Sewing Basket; Setting Of The Cloth Presser Block (Lifting Stroke); Lifting/Lowering Speed Of The Sewing Basket - DURKOPP ADLER 540 - 100 Operating Instructions Manual

9.

Sewing basket

9.1 Setting of the cloth presser block (lifting stroke)

9.2 Lifting/Lowering speed of the sewing basket

28
1
Standard:
The maximum stroke of 12 mm must not be exceeded. When
exceeding the stroke the needle thread scissors would be pressed
against the knife.
Setting:
–
Lower the sewing basket.
–
Loosen the screws 1.
–
Loosen the counternut 2.
–
Turn the threaded pin 3 according to the instructions.
Increase the stroke - turn the threaded pin in clockwise direction
Reduce the stroke - turn the threaded pin counter-clockwise.
–
Tighten counternut 2 and screws 1 again.
–
Lift and check the cage.
–
Turn the throttling screw 4 for adjusting the lifting speed.
–
Turn the throttling screw 5 for adjusting the lowering speed.
higher speed = Turn the throttling screw counter-clockwise
lower speed = Turn the throttling screw clockwise
2
3
4
5