Daytime Running Lights - If Equipped - Jeep Grand Cherokee 2013 Owner's Manual

206 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
To Activate
1. Enable the Automatic High Beams. Refer to "Elec-
tronic Vehicle Information Center (EVIC)/Customer-
Programmable Features" in "Understanding Your In-
strument Panel" for further information.
2. Turn the headlight switch to the AUTO headlight
position.
3. Push the multifunction lever away from you (toward
front of vehicle) to engage the high beam mode.
NOTE: This system will not activate until the vehicle is
at or above 20 mph (32 km/h).
To Deactivate
1. Pull the multifunction lever toward you (or rearward
in car) to manually deactivate the system (normal
operation of low beams).
2. Push back on the multifunction lever once again to
reactivate the system.
Daytime Running Lights — If Equipped
The Daytime Running Lights (low intensity) come on
whenever the engine is running, and the transmission is
not in the PARK position. The lights will remain on until
the ignition is switched to the OFF or ACC position or the
parking brake is engaged. The headlight switch must be
used for normal nighttime driving.
NOTE: The Daytime Running Lights will turn off auto-
matically when a turn signal is in operation and turn on
again when the turn signal is not operating.