Jeep Grand Cherokee 2013 Owner's Manual page 488

486 STARTING AND OPERATING
NOTE:
• If shift conditions/interlocks are not met, or a transfer
case motor temperature protection condition exists, a
"For 4x4 High Slow Below 3 MPH or 5 KPH Put Trans
in N Press 4 Low" message will flash from the Elec-
tronic Vehicle Information Center (EVIC). Refer to
"Electronic Vehicle Information Center (EVIC)" in
"Understanding Your Instrument Panel" for further
information.
• Shifting into or out of 4WD LOW is possible with the
vehicle completely stopped; however, difficulty may
occur due to the mating clutch teeth not being prop-
erly aligned. Several attempts may be required for
clutch teeth alignment and shift completion to occur.
The preferred method is with the vehicle rolling 0 to
3 mph (0 to 5 km/h). If the vehicle is moving faster
than 3 mph (5 km/h), the transfer case will not allow
the shift.
NEUTRAL Shift Procedure
1. Turn the ignition switch to the ON position, engine off.
2. Vehicle stopped, with foot on brake.
3. Place the transmission into NEUTRAL.
4. Hold down the NEUTRAL "pin" switch (with a pen,
etc.) for four seconds until the LED light by the switch
starts to blink indicating shift in progress. The light
will stop blinking (stay on solid) when the NEUTRAL
shift is complete.