Exterior Lights; Headlights And Parking Lights; Daytime Running Lights - If Equipped; High/Low Beam Switch - Jeep Wrangler JK 2018 Owner's Manual

18 wrangler user manual
Table of Contents

Advertisement

EXTERIOR LIGHTS

Headlights And Parking Lights

Turn the end of the multifunction lever to the first detent
for parking light operation. Turn to the second detent for
headlight operation.
Headlight Switch
Daytime Running Lights — If Equipped
The headlights come on at a low intensity level when
shifted into any position other than PARK (auto transmis-
sion) or when the vehicle begins to move (manual trans-
mission).
GETTING TO KNOW YOUR VEHICLE 53
NOTE: The Daytime Running Light, on the same side of
the vehicle as the active turn signal, will turn off automati-
cally when a turn signal is in operation and turn on again
when the turn signal is not operating.

High/Low Beam Switch

Push the multifunction lever toward the instrument panel
to switch the headlights to high beams. Pulling the multi-
function lever back toward the steering wheel will return
the lights to low beams.

Flash-To-Pass

You can signal another vehicle with your headlights by
lightly pulling the multifunction lever toward you. This
will cause the high beam headlights to turn on, and remain
on, until the lever is released.
Automatic Headlights — If Equipped
This system automatically turns the headlights on or off
according to ambient light levels. To turn the system on,
turn the end of the multifunction lever to the AUTO
position (third detent). When the system is on, the Head-
light Time Delay feature is also on. This means the head-
lights will stay on for up to 90 seconds after you turn the
3

Advertisement

Table of Contents
loading

Table of Contents