Table of Contents
Advertisement
4.5.2
Replacing the Hard Disk Drive
Follow these steps:
1.
Remove two screws that secure the hard disk drive to the inside frame assembly.
2.
Turn the hard disk drive over and pull out the hard disk drive cable from its connector.
1
Figure 4-14
Removing the Hard Disk Drive Bay Cover
If you want to install a new hard disk drive, reverse the steps described above.
4.5.3
Replacing Memory
Both memory slots (SIMM1 and SIMM2) are accessible after detaching the lower housing from the
inside frame assembly. You or the user can also upgrade memory (via one of the two available
memory slots, SIMM1) without disassembling the housing — accessed by opening the memory
upgrade door at the base of the unit.
Installing Memory Module(s)
Follow these steps to install memory module(s):
1.
Remove the memory module(s) from its shipping container.
2.
Align the connector edge of the memory module with the key in the connector. Insert the
edge of the memory module board into the connector. Use a rocking motion to fully insert the
module. Push downward on each side of the memory module until it snaps in place.
To remove the memory module, release the slot locks found on both ends of the memory slot
to release the DIMM. Then pull out the memory module.
•
•
Screw list:
•
M2.5L4 x2
2
Advertisement
Table of Contents
