Acer AcerNote 970 Service Manual page 146

Table 2-14 CL-PD6730 Pin Descriptions (continued)
Pin
Name
Socket Interface Pins (continued)
-INPACK Input Acknowledge: The -INPACK
function is not applicable in PCI bus
environments. However, for
compatibility with other Cirrus Logic
products, this pin should be
connected to the PC Card socket's -
INPACK pin.
RDY/ Ready / Interrupt Request: In
-IREQ Memory Card Interface mode, this
input indicates to the CL-PD6730
that the card is either ready or busy.
In l/O Card Interface mode, this input
indicates a card interrupt request.
-WAIT Wait: This input indicates a request
by the card to the CL-PD6730 to
delay the cycle in progress until this
signal is deasserted.
-CD[2:1] Card Detect: These inputs indicate
to the CL-PD6730 that a card is in
the socket. They are internally pulled
high to the voltage of the +5V power
pin.
-CE[2:1] Card Enable: These outputs are
driven low by the CL-PD6730 during
card access cycles to control
byte/word card access. -CE1 enables
even-numbered address bytes, and -
CE2 enables odd-2 or 3 numbered
address bytes. When configured for
8-bit cards, only -CE1 is active and
A0 is used to indicate access of odd-
or even-numbered bytes.
RESET Card Reset: This output is low for
normal operation and goes high to
reset the card. To prevent reset
glitches to a card, this signal is high-
impedance unless a card is seated in
the socket, card power is applied,
and the card's interface signals are
enabled.
Description Pin Number Pin Number
(socket A) (socket B)
110 1861
91 167
108 184
126, 61 202, 136
74, 70 150, 147
106 182
I/O Power
I-PU 2 or 3
I-PU 2 or 3
I-PU 2 or 3
I-PU
O*TS
O-TS 2 or 3