Conventions; Quality And Warranty; Exclusion Of Warranty - Studer XTH 3000-12 User Manual

STUDER Innotec
Xtender
usage must conform to the local safety instructions and applicable standards in the country
concerned.
2.2 C
ONVENTIONS
This symbol is used to indicate the presence of a dangerous voltage that is sufficient to
constitute a risk of electric shock.
This symbol is used to indicate a risk of material damage.
This symbol is used to indicate information that is important or which serves to optimise
your system.
All values mentioned hereafter, followed by a configuration no. indicate that this value may be
modified with the help of the RCC-02/03 remote control.
In general, the default values are not mentioned and are replaced by a configuration no. in the
following format: {xxxx}. The default values for this configuration are specified in the configuration
table, p. 40.
All configuration values modified by the operator or installer must be transferred into the
same table. If a parameter not appearing in the list (advanced configurations) has been
modified by an authorised person with technical knowledge, they will indicate the
number of the modified parameter(s), the specifications of the configuration(s) and the
new value set, at the end of the same table.
All figures and letters indicated in brackets refer to items of figures in the separate manual
"Appendix to the installation and operating instructions" supplied with the device.
The figures in brackets refer to elements belonging to the Xtender.
The uppercase letters in brackets refer to AC cabling elements.
The lowercase letters in brackets refer to battery cabling elements.
2.3 Q
UALITY AND WARRANTY
During the production and assembly of the Xtender, each unit undergoes several checks and tests.
These are carried out with strict adherence to the established procedures. Each Xtender has a
serial number allowing complete follow-up on the checks, according to the particular data for
each device. For this reason it is very important never to remove the type plate (appendix I – fig.
3b) which shows the serial number. The manufacture, assembly and tests for each Xtender are
carried out in their entirety by our factory in Sion (CH). The warranty for this equipment depends
upon the strict application of the instructions appearing in this manual.
The warranty period for the Xtender is 2 years.

2.3.1 Exclusion of warranty

No warranty claims will be accepted for damage resulting from handling, usage or processing that
does not explicitly appear in this manual. Cases of damage arising from the following causes are
notably excluded from the warranty:
Surge voltage on the battery input (for example, 48 V on the battery input of an XTH 3000-12)
Incorrect polarity of the battery
The accidental ingress of liquids into the device or oxidation resulting from condensation
Damage resulting from falls or mechanical shocks
Modifications carried out without the explicit authorisation of Studer Innotec
Nuts or screws that have not been tightened sufficiently during the installation or maintenance
Damage due to atmospheric surge voltage (lightning)
4 V.3.1.0 User manual