Combined System; Accessories; Control Centre And Rcc-02/03 (Remote Control) Display - Studer XTH 3000-12 User Manual

STUDER Innotec
Xtender

6.3.3 Combined system

It is possible to combine a three-phase system with one or several phases made up of 2 or 3
Xtenders in parallel. An example of cabling is given at fig. 15.
A combination of more than one inverter on only one (or two) phase is also possible. for example,
it's possible to build up one powerful phase for the most single phase consumer and the 2 other
phases with only one Xtender each for the 3 phase (motor) application as in the example Fig 15
Appendix I
It is therefore possible to combine up to nine Xtenders by running three Xtenders in parallel in a
three-phase grid. Examples of cabling are given in figs. 16 to 18 Appendix 1 and the comments on
p. 32.
6.4 A
CCESSORIES
6.4.1 Control centre and display RCC-02/03 (remote control)
An RCC-02/03 remote display and programming unit can be optionally connected to the Xtender
via one of the two RJ45-8-type "Com. Bus" (3) connectors.
These connectors may only be used for connecting a CAN-ST compatible accessory, excluding
any other connection such as LAN, Ethernet, ISDN, etc.
The RCC-02/03 control centre is vital for modifying device configurations.
It also allows the following functions:
Display of function synopsis
Display of the measured operational values (current / voltage / power output, etc.)
Updating of software or implementation of customised software
upload/download of inverter configuration
Updating of inverter configurations
Events logging of error message
RCC-02
RCC-03
The features of the RCC-02 and the RCC-03 are the same. They only differ in their external
appearance. The RCC-02 is designed for wall mounting, whereas the RCC-03 is designed as a
board device.
The RCC-03 model must be taken off the table to allow access to the SD card slot (during
updating, for example).
Model N°: RCC-02: Dimensions: H x W x D / / 170 x 168 x 43.5mm
RCC-03: Dimensions: H x W x D / / 130 x 120 x 42.2mm
User manual V.3.1.0 27