Table Of Standard Configurations - Studer XTH 3000-12 User Manual

STUDER Innotec
Xtender

17 TABLE OF STANDARD CONFIGURATIONS

No. of
config.
1107 Maximum current of the AC source
1108 Under voltage of the empty battery
1109 Sub-voltage of the charged battery
Restart voltage of the inverter after under voltage of the
1110
battery
1111 Automatic startup at power up
1112 Inverter frequency
1121 Maximum DC voltage for stopping the Xtender
1126 Source assistance (Smart Boost) permitted
1138 Battery charge current
Battery voltage correction according to the temperature
1139
1140 Battery maintenance voltage
1143 Voltage 1 to allow a new battery cycle
1144 Duration of under voltage 1 to allow a new cycle
1145 Voltage 2 to allow a new battery cycle
1146 Duration of under voltage 2 to allow a new cycle
1156 Battery absorption voltage
1157 Duration of absorption
1159 Current at end of absorption
1161 Minimum interval between absorptions
1187 Sensitivity of the charge detection (100% approx.25W)
1188 Number of pulse load reserach
1189 Time interval between load search pulses
1190 Duration of under voltage of battery before disconnection
1191 Dynamic compensation for under voltage
1194 Battery adaptive low voltage allowed
1195 Max voltage for adaptive low voltage
1198 Time elapsing before transfer relay opens
1199 ACin voltage causing the opening of the transfer relay
1200 Immediate open critical threshold for the transfer
Auxiliary contact 1 activated by voltage 1 {1247} after delays
1246
{1248}
1247 Voltage 1under which auxiliary contact 1 is activated
1248 Delays on voltage 1 to activate auxiliary contact 1
Auxiliary contact 1 activated by voltage 2 {1250} after delays
1249
{1251}
1250 Voltage 2 under which auxiliary contact 1 is activated
1251 Delays on voltage 2 to activate auxiliary contact 1
Auxiliary contact 1 activated by voltage 3 {1253} after delays
1252
{1254}
1253 Voltage 3 under which auxiliary contact 1 is activated
1254 Delays on voltage 3 to activate auxiliary contact 1
Voltage 1above which auxiliary contact 1 is deactivated
1255
after delays
1256 Delays on voltage {1255} to deactivate auxiliary contact 1
1258 Auxiliary contact 1 activated by power 1
1259 Power 1 above which auxiliary contact 1 is activated
1260 Duration of power 1 for activating auxiliary contact 1
The second value concerns the 120Vac ranges
2
40
Denomination / description
V.3.1.0
Fact.
Units
value value
2
A 30
V/cell 1.93
V/cell 1.75
V/cell 2
y/n no
Hz 50 / 60
V/cell 2.84
y/n no
A 60
mV/°C/ -5
cell
V/cell 2.27
V/cell 2.1
min. 30
V/cell 1.93
sec. 180
V/cell 2.4
h 2
Adc 10
h 3
% 10
-- 1
sec. 0.8
min. 3
y/n yes
o/n no
V/cell 2.08
sec. 8
Vac 180 / 90
Vac 100 / 50
y/n yes
V/cell 1.95
min. 1
y/n yes
V/cell 2
min. 10
y/n yes
V/cell 2.05
min. 60
V/cell 2.25
min. 60
y/n yes
% 120
min. 1
User manual
Mod.