Maintenance Of The Installation; Product Recycling - Studer XTH 3000-12 User Manual

STUDER Innotec
Xtender
(45) This indicator is glowing continuously when a n alternative voltage with correct values, either in
frequency {1112-1505-1506}, or in voltage {1199} is present at the AC IN input of the device and the
current limit set by the user has not been reached. It flashes when the current limit at the input
{1107} set by the user has been reached. In this case the charger current is reduced in order to
guarantee priority supply to the users (see chap. 6.2.5 p. 22). If the input current is exceeded
nevertheless, the Xtender goes back to inverter mode (transfer relay open) and the indicator (42)
will keep flashing as long as the user current exceeds the limit value of the input current {1107}.
If the smart boost mode (see chapter 6.2.6 – p.23) is used and the inverter is part of the user supply –
therefore the battery is discharged – the "charge" indicator (44) will be glowing.
(46) This indicator is glowing continuously when an alternative voltage of 230V is present at the
equipment output. It flashes when the device is in "load search" mode according to chapter 6.2.2
– p. .
20
(47) Receipt button to stop the acoustic warning (XTM only). The duration of the acoustic alarm
{1565} is factory settled to 0 sec (deactivated).

8 MAINTENANCE OF THE INSTALLATION

With the exception of the periodic checking of connections (tightening and general condition) the
Xtender does not require any special maintenance.

9 PRODUCT RECYCLING

The model of the Xtender series conform to the European directive 2002/95/EC on hazardous
substances and does not contain the following elements: lead, cadmium, mercury, hexavalent
chrome, PBB or PBDE.
To dispose of this product, please use the service for the collection of electrical waste and observe
all applicable obligations according to the place of purchase.
User manual V.3.1.0 31