Cabling - Studer XTH 3000-12 User Manual

STUDER Innotec
Xtender
Pos. Denomination Description
ON/OFF
1
Main switch
2 Temp. Sens
3 Com. Bus
O / T
4 (Open /
Terminated)
5 --
6 --
REMOTE
7
ON/OFF
AUXILLARY
8
CONTACT
9 --
10 L1/L2/L3
11 +BAT
12 -BAT
13 AC Input
14 AC Output
15 RCM-10

4 CABLING

The connection of the Xtender inverter / charger is an important installation step.
It may only be carried out by qualified personnel and in accordance with the applicable local
regulations and standards. The installation must always comply with these standards.
Pay attention that connections are completely tightened and that each wire is connected at the
right place.
10
Main on/off switch
Connector for the
temperature sensor
Double connector
connecting peripherals such as
the RCC002/03 or
Xtender units
Switch for terminating
communication bus.
3.3 V (CR-2032) lithium ion type
battery socket
Jumper for programming the
off/on switch by dry contact
Entry command terminals..
In XTM series, this entry is
deported on the
command module
See chap. 6.4.3 – p. 28
Auxiliary contact
Activation indicators
auxiliary contacts 1 and 2
Phase selection jumpers.
Positive pole
connection terminals
Negative pole
connection terminals
Connection terminals for the
alternative power
(generator or public network)
Connection terminals for the
device output.
Connector for RCM-10 module
Comment
See chapter 7.1 - p 29.
In XTM series, this function is deported on
the remote command module RCM-10.
See chap.6.4.3 – p.28
battery See chapter 6.4.2 – p. 28.
Only connect the original Studer BTS-01
sensor
for See chapter 4.5.9 – p. 17.
The two termination switches (4) for the
other communication bus both remain in
position T (terminated) except when
both connectors are in use.
the
Used as a permanent supply for the
internal clock. See chapter The real time
clock 6.2.11 - p 25.
See chapter 6.2.12 – p. 24 and fig. 8b
point (6) and (7). They are positioned at
A-1/2 and B-2/3 by default
Allow to dive a function – to be defined
by programming – by the closing of a dry
remote contact or by the presence of a voltage
RCM-10. across these terminals. See chapter
6.2.12– p. 24).
(See chapter 6.2.10– p. 24)
Take care not to exceed the admissible
loads
for See chapter 6.2.10– p. 24
See chapter 6.3.1. – p.26.
Jumper default at position L1
battery Carefully read chapter 4.5 – p.14
Take care with the polarity of the battery
battery and when tightening the clamp.
See chapter 4.5.7 - p. 17.
supply Note: It is imperative that the PE terminal
be connected.
See chapter 4.5.6 - p. 17.
Note: Increased voltages may appear
on the terminals, even in the absence of
voltage at the input of the inverter.
Only on XTM. See chap. 6.4.3 – p.28
V.3.1.0 User manual