Bts-01 Temperature Sensor; Remote Command Module Rcm-10 - Studer XTH 3000-12 User Manual

STUDER Innotec
Xtender
Th e two remo ote control m
Ca ables of spe ecific length
Th e article no o. is as follow
Up to 3 RC CC-02/03 re mote contr
Xtender o or an Xten der multi-in
connectio n of the RC CC-02 or RC
When con necting an n RCC-02/03
units in the e system b e stopped
connectio n is being m made be ter
Th e 2 switche es for the c
po osition T (ter rminated) e
thi is case, bot h must be p
in use, the two o terminatio
6.4.2 B TS-01 tem mperature
The optima al operatin g voltages
temperatu ure. A temp perature se
battery vo oltage and
temperatu ure. The cor rrection fac
set by the configuratio on {1139}
Article no. for the tem mperature se
Dimensions s: H x W x D
6.4.3 Re emote co ommand
The option nal remote command
function:
Main ON/O OFF comma and see cha
Command d entry see c chap.6.2.12
Note : the cable lengt th on this en
28
models are
hs (5 m, 20 m m and 50 m
ws: CAB-RJ4
rols can be
nverter syst tem. In a
CC-03 may y be condu
3 remote co ontrol in a m
and that
rminated.
communica ation bus te
xcept when n both con
placed in th he O open p
on switches
e sensor
for lead b batteries va
ensor is opt tionally ava
guarantee an optimu um charge
ctor given b by the corre
ensor (includ ding a cable
/ / 58 x 51.5 5 x 22 mm
Modul R RCM-10
modul for
ap.7.1 below w.
2 – p.25
ntry is limited d to 5 m.
delivered w with a 2 m c cable by de
) can be or rdered.
5-xx. The len ngth in met
connected d in series o
system co omprising a
ucted witho out stopping
multi-unit sy ystem, it is re
the commu unication b bus on the
ermination,
nectors are e in use. In th
position. If o one of the tw
(14) will be in position T
ary depend ding on the
ailable to c correct the
whatever t
ection of th he sensor is
e of 3 m): B
XTM range gives the p possibility to
V.3.1.0
fault.
res is specifi ied as xx
n the comm munication
a single Xt
g the Xtend
ecommend
device on
"Com. Bus" " (4) both r
his case, an nd only in
wo connect
T.
the battery y
TS-01.
o have the
User manual U
bus of one e
ender, the e
der (warm). .
ded that all l
which the e
remain in
tors is not
2 following g
l