Control And Display Parts For The Xtender (Fig. 4B) - Studer XTH 3000-12 User Manual

STUDER Innotec
Xtender
Pos. Denomination
13 AC Input
14 AC Output
17 --
18 --
19

15 CONTROL AND DISPLAY PARTS FOR THE XTENDER (FIG. 4B)

See chapter 7.2 - p. 29.
Pos. Denomination
41
42 OFF
43 ON
44 Charge
45 AC in
38
Description
Connection terminals for the
alternative power
(generator or public network)
Connection terminals for the
device output.
Supplementary terminal
protective earth
Mounting hook-up
Access shutter to
fastening screw.
Description Comments
ON/OFF button The ON/OFF button allows the start up or complete
stoppage of the system such as it has been
programmed. When there are several units in the
same system, each unit must be started up or
stopped individually using this button.
Light indicator When the light indicator flashes it indicates the cause
for stoppage of the stoppage of the unit, its imminent stoppage or
of the unit the limitation of its rated power output according to
chapter 7.2 - p.29.
Light indicator This indicator is glowing continuously when the
showing that device is working. It flashes when the equipment is at
the equipment a temporary stop. Note: The equipment will restart
is in operation automatically when the conditions that led to the
temporary stoppage have gone away.
Light indicator This indicator is glowing continuously when the
showing that charger is in operation and has not yet reached the
the battery is absorption phase.
being charged It flashes twice during the absorption phase and
once during the maintenance phase.
If smart boost mode has been activated it is possible
that this indicator will go out temporarily when source
backup is required by users. (See chapter
)
23
Light indicator This indicator is glowing continuously when an
showing the alternative voltage with correct values is present at
presence of the AC IN input (13) of the device and the current
correct and limit {1107) set by the user has not been reached. It
synchronised flashes when this limit is reached (see chapter 6.2.5 –
input voltage p. 23).
V.3.1.0
Comment
See chapter 4.5.7 - p. 17.
supply Note: It is imperative that the PE
terminal be connected.
See chapter 4.5.6 - p. 17.
Note: Increased voltages may appear
on the terminals, even in the absence
of voltage at the input of the inverter.
for This terminal can be used if the
required earth cable cross-section is
too big to be connected in the
terminal 13 or 14
the top Full tightening of the top fastening
screw may be required in mobile
application or in case of heavy
vibration
apparatus.
of the support of
6.2.6
User manual
the
- p.