Grip Adjustment; Viewfinder Adjustment; Shoulder Strap Attachment; Tripod Mounting - JVC GR-DVL9800 Instructions Manual

8
EN
Power Zoom Lever
Recording Start/
Stop button
Power Switch
Dioptre Adjustment
Control
PAUSE
2
Shooting Mode Dial
1
3
GETTING STARTED

Grip Adjustment

1
Separate the Velcro strip.
2
Pass your right hand through the loop and grasp
the grip.
3
Adjust so that your thumb and fingers can easily
operate the Recording Start/Stop Button and
Power Zoom Lever. Refasten the Velcro strip.

Viewfinder Adjustment

1
Set the Power Switch to "
1
pressing down the Lock Button located on the
switch. Set the Shooting Mode Dial to any
position.
2
Pull out the viewfinder fully and adjust it
manually for best viewability.
3
Slide the Dioptre Adjustment Control until the
indications in the viewfinder are clearly
focused.

Shoulder Strap Attachment

1
Following the illustration, thread the strap
through the eyelet
thread it through the buckle
procedure to attach the other end of the strap to
3
the other eyelet
twisted.

Tripod Mounting

1
Align the screw and camera direction stud on
the tripod with the camera's mounting socket
and stud hole. Then tighten the screw.
•Some tripods are not equipped with studs.
CAUTION:
When using a tripod, be sure to open and
extend its legs fully to stabilise the
camcorder. To prevent damage to the unit
caused by falling over, do not use a small-
sized tripod.
(cont.)
" or " " while
1
, then fold it back and
2
. Repeat the
, making sure the strap is not