JVC GR-DVL9800 Instructions Manual page 82

82
EN
SYMPTOM
20. The Picture Wipe and
Dissolve functions do not
work.
21. The picture wipe function
does not work.
22. Scene transition does not
go as expected.
23. The Video Echo mode
does not work.
24. Even when Slow Shutter is
not selected, the image
looks like it is activated.
25. There is no strobe when
the Classic Film or Strobe
mode is activated.
26. White Balance cannot be
activated.
TROUBLESHOOTING
POSSIBLE CAUSES
20. •The last selected editing
scene is ending.
•At the end of the last
selected scene for editing,
the Power Switch was set to
"OFF".
•The power is off.
21. •The Slow Shutter mode is
activated.
•"WIDE MODE" is not set to
"OFF".
22. •When using "Picture Wipe/
Dissolve" ( pg. 38), there
is a delay of a fraction of a
second between the
previous record stop-point
and the Dissolve start-point.
This is normal, but this slight
delay becomes especially
noticeable when shooting
fast-moving subject or
during rapid panning.
23. •The Picture Wipe or
Dissolve functions are in use.
•"WIDE MODE" is set to
"SQUEEZE" or "PS WIDE"
in the Menu Screen.
•A Fade-In or Fade-Out is in
progress.
24. •When shooting in the dark,
the unit becomes highly
sensitive to light and the
image takes on an effect
similar to Slow Shutter.
25. •The Picture Wipe or
Dissolve function is in use.
26. •The Sepia or Monotone
mode is activated.
CORRECTIVE ACTION
20. •Select Picture Wipe or
Dissolve before beginning
recording. The effects are
then automatically activated
( pg. 38).
•Do not turn off the
camcorder's power after
setting Edit-In and Edit-Out
points, as they will all be
erased ( pg. 38).
•The camcorder automati-
cally shuts off after 5
minutes have elapsed in the
Record-Standby mode.
Make sure you continue
operations within 5 minutes
after engaging Record-
Standby mode (
21. •Disengage the Slow Shutter
mode or set "WIDE MODE"
to "OFF" before preparing
to use the Picture Wipe
( pg. 32, 38, 40).
22.
————
23. •Set "WIDE MODE" to
"CINEMA" or "OFF" mode
( pg. 32).
•Do not try to use the Video
Echo mode during a Fade-In
or Fade-Out (
24. •If you want the lighting to
look more natural, set GAIN
UP to "AGC" or "OFF" in
the Menu Screen
( pg. 31).
25. •Do not try to use the Classic
Film or Strobe mode during
a scene transition
( pg. 38, 40).
26. •Turn off Sepia or Monotone
before setting White
Balance ( pg. 40, 43).
(cont.)
pg. 38).
pg. 38, 40).