JVC GR-DVL9800 Instructions Manual page 21

There is the sound of a shutter closing.
To Delete Unwanted Still Images . . .
Snapshot mode
.... when unwanted still images are stored in the
with no frame
To Remove The Shutter Sound . . .
.... when you do not want to hear the shutter sound, set
NOTES:
Even if "DIS" is set to "ON" (
will be disabled.
If Snapshot recording is not possible, "PHOTO" blinks
when SNAPSHOT is pressed.
If Programme AE with special effects (
engaged, certain modes of Programme AE with special
effects are disabled during Snapshot recording. In such a
case, the icon blinks.
If shooting is not performed for approx. 5 minutes when
the Power Switch is set to "
supplied from the battery pack, the camcorder shuts off
automatically to save power. To perform shooting again,
close the LCD monitor and re-open it. When using the
viewfinder, push back it in and pull it out again.
The Motor Drive mode (
Shooting Mode Dial is set to "VGA" or "XGA".
To reduce the Red-Eye effect in the subject's eyes when
the flash fires,
When a headphone set is connected to the PHONE
connector, the shutter sound is not heard from the
speaker.
Still images taken are compliant to DCF (Design rules for
Camera File systems). They do not have any
compatibility with devices which are not compliant to
DCF.
In the XGA mode, images shot using a 800,000-pixel
Progressive Scan CCD (effective area: 720,000 pixels,
962 x 774 pixels) are converted and stored in the XGA
mode file size (1024 x 768 pixels).
MultiMediaCard or its memory is full, refer to
"Deleting Images" ( pg. 51) and delete unwanted
still images.
BEEP/TALLY to "OFF" on the Menu Screen
( pg. 30, 31). The sound is no longer heard from the
speaker.
pg. 34.
21
EN
pg. 32), the Stabiliser
pg. 40) is
" or " " and power is
pg. 18) is disabled when the