JVC GR-DVL9800 Instructions Manual page 57

Display
EXIT DPOF
100-DVC00021 VGA
0 1 9 0 0 0 2 0 0 0 0 2 1
0 2 3
0 2 2 0 0 0 0 0 2 4
C A N C E L
E X E C U TE
MENU/
BRIGHT Wheel
DPOF Screen
0 3
0 0
Confirmation
Screen
TO PRINT BY SELECTING STILL IMAGES
AND NO. OF PRINTS
1
Perform steps 1 through 4 on pg. 56.
2
Rotate MENU/BRIGHT to select "SELECTED" and
press it. Selection is complete. The DPOF Screen
appears.
3
Rotate MENU/BRIGHT to move the green frame to
the image you wish to print and press it.
4
Select the number of prints by rotating MENU/
BRIGHT towards "+" to increase the number, or
towards "–" to decrease the number and press it.
Repeat steps 3 and 4 for the desired number of prints.
•The number of prints can be set up to 15.
•To correct the number of prints, select the image
again and change the number.
5
Rotate MENU/BRIGHT upward to select "EXIT" and
press it. Selection is complete. The Confirmation
Screen appears.
6
Rotate MENU/BRIGHT to select "EXECUTE" and
press it. The normal playback screen appears.
•To cancel selection, rotate MENU/BRIGHT to select
"CANCEL" and press it.
To Reset The No. Of Prints . . .
.... select "RESET" in step 5 on pg. 56. The number of
prints is reset to 0 for all still images.
CAUTION:
While performing the above, never disconnect power,
as this may cause the memory to be corrupted. For
safety, all buttons including the Power Switch are
disabled in step 5.
NOTE:
To print images recorded on a tape, first dub them to a
MultiMediaCard ( pg. 67).
57
EN