Dubbing Images Stored In A Multimediacard To A Tape - JVC GR-DVL9800 Instructions Manual

66 66
EN EN
Rewind Button (2)
Fast-Forward Button (3)
T O C
P US H
Power Switch
Lock Button
Recording Start/
Stop Button
Display
S P – – –
OP Y T O T A P E
S TA R T / S T O P
444
SP
Dubbing Images Stored In A
MultiMediaCard To A Tape
Images can be dubbed from a MultiMediaCard to a tape.
1
Load a MultiMediaCard (
( pg. 10).
2
Set the Power Switch to "
the Lock Button located on the switch. Open the LCD
monitor fully or pull out the viewfinder fully.
3
To locate the point where you wish to dub a still
2
image, play back the tape. Stop playback at the
desired point.
4
Set the Power Switch to "
3
down the Lock Button located on the switch.
To select a still image to be dubbed, perform Index
Playback ( pg. 49), Auto Playback (
press 2 or 3 to select the image you wish.
5
To engage Dub-Standby, press the Recording Start/
Stop Button. The message "TO COPY TO TAPE PUSH
START/STOP" appears.
6
While the message is being displayed, press the
Recording Start/Stop Button. The selected still image
is recorded on the tape for approx. 6 seconds.
•The "SP" or "LP" and tape running indicators
disappear when dubbing is complete.
NOTES:
If the Recording Start/Stop Button is pressed in step 5
when the tape's erase protection tab is set to "SAVE", the
message "COPYING FAILED" is displayed.
The XGA image is dubbed onto the tape at 720 x 640
pixels.
You can superimpose a print frame over the selected still
image to be dubbed (
After step 4, superimpose a print frame over the still
image and go to step 5.
DUBBING
(cont.)
pg. 12) and cassette
" while pressing down
" while pressing
pg. 48) or
pg. 52) and dub it to a tape.