40
12. Introduce tape into the guide piece (12) and let it run through
until there is no excess tape any longer between the pneumatic
clamp (11) and the guide piece (12). Grip the tape with, e.g.,
tweezers.
13. End threading mode by pressing on one of the two keys on
the key panel (9).
The tape is cut at the bottom end of the guide piece (12).
Important
If the piece of tape cut off is too short, it can be pulled into
the bushing and prevent the feeding of the tape.
5.8.1
Feeding the tape
7 Software settings, pg. 67
5.9 Setting the sewing foot pressure
The adjusting wheel (1) and rotary button (2) on the machine head
are used to regulate the pressure of the sewing feet on the sewing
material. Here, the center foot and top feed foot can be adjusted
separately.
Correct setting
The sewing material does not slip and is fed through correctly.
The correct sewing foot pressure depends on the sewing material.
Faults due to incorrectly set sewing foot pressure
• Excessively high sewing foot pressure:
Indentations in the sewing material, possible ruffing of the
sewing material.
• Excessively low sewing foot pressure:
Slipping of the sewing material, stitch length too short.
Operating Instructions 610/630 - 00.0 - 05/2014
Operation