68
7.2 Switching on the sewing machine
1. Switch on the main switch.
The OP7000 control panel is switched on.
• On the display, the machine class is shown on the left
and the firmware on the right.
• The sewing machine references.
• Then, the control panel goes to the mode that was active
when it was switched off – MAN or AUTO.
7.3 Controller operating modes
The controller has four operating modes:
• Manual mode MAN
Manual mode is the simplest of the operating modes.
There are no seam programs and no inputs for individual seg-
ments.
Changes to fullness, stitch length, thread tension, curve
support as well as the switching of other functions are
implemented immediately.
In this way all the essential sewing parameters can be
changed manually during the sewing process.
• Automatic mode AUTO
In automatic mode, seam programs are sewn.
The seams in the seam programs are subdivided into individ-
ual segments, to which individual sewing parameters such
as fullness etc. are assigned.
• Programming mode
In programming mode, new seam programs can be created
(PROGRAMMING),
amended, deleted, copied and mirrored (EDIT).
existing
seam
Operating Instructions 610/630 - 00.0 - 05/2014
Software settings
programs
can
be