34
Setting the thread regulator
1. Turn the handwheel until the thread lever reaches its lower
end position.
2. Loosen the fastening screws (1) of the thread regulator (2).
3. Move the thread regulator (2) to the correct position.
• For tight/normal seams and less elastic threads
(detail image (a)):
( 5.7.3 Adjusting the needle thread quantity, pg. 33)
Feed the thread through the thread lever (3) and then directly
downwards.
• For elastic seams (detail image (b)):
Feed the thread through the thread lever (3) and then via
the left bar of the thread regulator (2).
4. Tighten the fastening screws (1) of the thread regulator (2).
5.7.4
Adjusting the looper thread quantity
WARNING
Risk of injury from moving parts.
Switch off the sewing machine before adjusting
the thread take-up.
The looper thread take-up adjusts the looper thread quantity to the
relevant set stitch length so that the stitch pull is optimal for every
length and also for stitch condensing.
The looper thread take-up can be adjusted continuously on a scale
from 0 to 5. The larger the value, the greater the released thread
quantity and the more elastic the seam.
Operating Instructions 610/630 - 00.0 - 05/2014
Operation