Panasonic Section 700 Operation page 38

Section 700 - Operation
l
l
FF2 (Trunk): DISA Auto Answer
l
FF2 (Trunk): DISA Start Tie
l
FF2 (Trunk): DISA End Time
l
To program an incoming code from an attendant phone:
In addition to the DISA ID Setting in FFl, the following procedure can be
used to program an incoming code.
1. Press the ON/OFF key.
2. Press the CONF key.
3. Dial "#7."
4. Enter the DISA code.
5. Press the HOLD key.
6. Press the ON/OFF key.
Hard ware Requirements
l
Considerations
l
. With CPC-A and CPC-I3 Versions 2.0 to 2.1, DISA calls cannot access
DBS-70-700
The phone issues intercom dial tone.
l
The ON/OFF LED lights.
l
The ON/OFF LED goes off.
An MFR card is required for DISA. The MFR card is required to detect
DTMF tones entered via the DISA connection.
DISA can be used to access extensions as well as outside numbers.
Once an incoming DISA code is entered, you cannot blank it out without
entering the programming mode.
Busy override cannot be used for a DISA line.
hunt groups.
DBS Manual - Issued 8/l/95
Chapter 2. System Features
Page 2-23