Renault Clio Cup User Manual page 16

2010 Release
Subframe
Removal
-
Remove the intermediate shaft (see 4-4 Steering/Intermediate shaft).
1 -
Note: Do not turn the wheel when the shaft is not connected to the steering unit.
2 - Remove the connecting torque rod.
Place a hydraulic plate in contact under the
3 -
subframe.
Remove the wheel speed sensors (2) at the
4 - level of the pivots and disconnect them from
the support (3) on the steering tie-rod.
5 - Remove the point E nuts (4).
Extract the EE' support from the point E ball
6 - joint; a ball joint puller must be used to do
this.
Operation
E-16
Photos
2
3
4