Installation Of The Indoor Unit - Rinnai RINV25R-A Installation Manual

Split type wall mounted air conditioner
Hide thumbs Also See for RINV25R-A:
Table of Contents

Advertisement

Installation of the indoor unit

Wall
Indoor
Outdoor
15mm
Pipe
Ring
connection
70 hole
Putty
Drilling 70mm diameter
pipe hole at the left down
or right down side of the
installation board. The
hole shall slant outward
slightly.
Wall
Air-conditioner
Cable
Connection
Outflow tube
pipe
Installation
Cable
board
●Arrange the connection pipes, cable, outflow tube according to the figure , then
connect the drain pipe to the draining hole.
●Use insulation sleeve to warp the position of connection pipe and indoor unit, then
wrap the insulating tape on the sleeve to avoid condensate water.
●Fasten connection pipes, cables and drain pipe together by plastic strap.
●First make changes to wall and make sure that is hard
and secure. Using four + type screws to fasten the
installation board onto the wall. Use a spirit level to
ensure both horizontal and vertical level to ensure proper
operation and drainage of condensate tray and drain line.
Connection pipe
Nut
pipe
Spanner
Spanner
Remove the base
support foam in one side
before installation.
Wall
Base
Connection pipe
Outflow tube
Installation board
Connection wire
Water discharge pipe
" "
Pull out the indoor unit pipes after
detached the fixed parts on them.
Connect the interconnected pipes to
the indoor unit: point to the center of
pipe and fasten the connection screw
at first by hand and then by wrench
until you hear the Click sound.
Fastening direction is shown in the
right picture. Using torque is shown
in the following table.
Foam
Note: The installed air-conditioner
won't be tightly pressed to the
wall if it is not arranged shown in
Cable
the picture. The outflow tube must
be in the bottom and the highest
point of it can not exceed the
position of water basin.
●Hang the indoor unit to the board
and make sure the machine is in
the middle of the board.
●Pushing the machine towards the
left down and right down side of
the installation board until the
hangers enters tightly the grooves
(it makes click sound)
"
- 10 -
"
"
Drain pipe
Connection pipe
Cable
Plastic strap
"

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rinv35r-aRinv70r-a

Table of Contents