TANDBERG Educator & Professional MXP Instructions Manual page 51

TANDBERG Educator & Professional MXP Videoconferencing System
1. Ensure proper connection of the second camera to the TAM – control and video, and
2. Navigate from the main conference page to the AUDIO/VIDEO SOURCES page:
3. Select CAMERA #2 under 'Source.' When you select a source, the 'Source
4. In the 'Source Configuration' area, press 'Activate' to enable 'Camera #2.' The
5. In the 'Source Configuration' area, you can press 'Change Icon' to select a different
6. In the 'Source Configuration' area, press the 'Rename Source' button if you wish to
7. In the 'Custom Settings' area, you will see the 'Change Model Type' button. Press
8. Press COMPLETE when you are finished with configuration, or repeat the procedure
D50326.05
supply power to the camera as well. It is recommended that you connect your device
before you proceed with configuration. If the camera is not connected before you
configure it to the system, you will have to repeat much of the following procedure for
verification, as well as make sure that you identify the specific camera you have
connected.
Utilities > System Setup > AUDIO/VIDEO SOURCES
Configuration' and 'Custom Settings' areas will appear with the appropriate options.
button will change to ACTIVE.
icon that will be associated with 'Camera #2.' The selected icon is what will be
displayed on your touch panel.
associate a specific name to 'Camera #2.' A keyboard will appear for you to type in
the desired name. Press DONE on the keyboard to accept the given name.
this button repeatedly to toggle though the set of identifiable devices until you see
your specific device -- SONY EVI-D100.
If you did not connect the second camera before configuration, you will not see the
specific device in 'Change Model Type.' You must return to the AUDIO/VIDEO
SOURCES page, select 'Camera #2', and select the specific camera in 'Change
Model Type.'
if you wish configure another device.
TOUCH PANEL OPERATION
51