Precor P10 Operating And Maintaining page 55

Maintenance
To review and reset the status of the treadmill:
1.
2. Use the up and down arrow keys to scroll through the
3. In the Hardware Validation menu, use the up and down
4. Press and hold the Quick Start key until the status light
5. Press the Pause key to return to the Welcome banner.
Note: If the status light is steady yellow, you can also clear it
by reviewing and clearing the entries in the event log (refer to
Viewing the Informational Displays).
To adjust the brightness of the status light:
1.
2. Use the up and down arrow keys to scroll through the
3. In the Hardware Validation menu, use the up and down
4. Scroll through the available settings (LOW, MED, and
At the Welcome banner, press the Pause key, then enter
the following digits on the keypad:
5 1 7 6 5 7 6 1
menu names until HARDWARE VALIDATION appears.
arrow keys to scroll through the menu options until
ACTIVE STATUS LIGHT appears, then press OK again.
returns to a steady blue color.
At the Welcome banner, press the Pause key, then enter
the following digits on the keypad:
5 1 7 6 5 7 6 1
menu names until HARDWARE VALIDATION appears.
arrow keys to scroll through the menu options until AS
LIGHT BRIGHTNESS appears, then press OK again.
HIGH) to select the brightness level you want, then press
OK.
53