Hard drive
NOTE:
The hard drive spare part kit includes the hard drive rubber bracket and screws. These components
are included in the Hard Drive Hardware Kit, spare part number 732071-001.
Description
1 TB, 5400 rpm, 7.0 mm/9.5 mm
750 GB, 5400 rpm, 9.5 mm
500 GB, 5400 rpm, 9.5 mm
500 GB, 5400 rpm, 7.0 mm
1 TB, 5400 rpm + 8 GB NAND hybrid, 9.5 mm, for use with computer models with Intel processors
750 GB 5400 rpm + 8 GB NAND hybrid, 9.5 mm, for use with computer models with Intel processors
500 GB 5400 rpm + 8 GB NAND hybrid, 7 mm, for use with computer models with Intel processors
Hard Drive Hardware Kit (not illustrated, includes hard drive rubber bracket, 2 hard drive retention
brackets, and hard drive connector cable).
Before removing the hard drive, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
a.
Optical drive (see
b.
Service door (see
c.
WLAN module (see
d.
Memory module (see
e.
Keyboard (see
f.
Top cover (see
Remove the hard drive:
1.
Disconnect the USB/audio cable (1) by flipping open the ZIF connector and lifting the cable. Remove the
USB/audio cable Phillips M 2.5×3.0 screw (2) and then lift the USB/audio board (3).
Battery on page
40), and then remove the following components:
Optical drive on page
Service door on page
WLAN module on page
Memory module on page
Keyboard on page
51).
Top cover on page
55).
45).
42).
44).
42).
Component replacement procedures
Spare part number
676521-005
634250-005
669299-005
683802-005
731999-005
732001-005
732000-005
732071-001
59