Table of Contents
Advertisement
Chapter 3 Configuring the Device
E
STABLISHING AN
To assure continuous traffic flow in the event of system failure, you can cable and
configure two NetScreen devices in a redundant cluster. The devices propagate all
network, configuration and session information to each other. Should one device fail, the
other takes over the traffic processing.
Note:
For the NetScreen-204, the default HA interface is ethernet4. For the
NetScreen-208, the default HA interface is ethernet8. (Each is bound to the HA
security zone.)
The following diagram shows a typical HA setup for NetScreen-208 devices.
Layer-3 Switch 1
Device 1
Switch 3
20
HA C
ONNECTION
Router
To ethernet2
To ethernet1
B
ETWEEN
Internet
To ethernet3
To ethernet3
To ethernet2
DMZ
DMZ LAN
LAN
D
EVICES
Router
Layer-3 Switch 2
Device 2
To ethernet8
To ethernet1
Switch 4
User's Guide
Advertisement
Table of Contents
