Asset Recovery Pinhole - Juniper 200 Series User Manual

Chapter 1 Overview
Alarm
Status
Flash

Asset Recovery Pinhole

The Asset Recovery Pinhole is a button that resets the device to its original default
settings. To use this button, insert a stiff wire (such as a straightened paper clip) into the
pinhole.
Warning: Because resetting the device restores it to the original default configuration, any
new configuration settings are lost, and the firewall and all VPN service become
inoperative.
4
System Alarm red
amber
off
Session amber
Utilization
red
off
Memory Card green
Status
blinking green
off
Critical alarm:
• Failure of hardware component or software
module (such as a cryptographic algorithm).
• Firewall attacks detected.
• HA status changed
Major alarm:
• Low memory (less than 10% remaining).
• High CPU utilization (more than 90% in use).
• Session full.
• Maximum number of VPN tunnels reached.
• HA redundant group member not found.
No alarms.
Session utilization is between 70% and 90%.
Session utilization is greater than 90%.
Normal operation.
The card is installed.
Read-write activity is detected.
Flash card slot is empty.
User's Guide