Figure 26. Cover removal
3. If the server has been installed in a rack, slide the server out from the rack
4. Press down firmly on the blue tab on the top (near the front of the server) of
5. Lift the server cover off the server and set it aside.
Removing the DIMM air baffle
Use this information to remove the DIMM air baffle.
About this task
To remove the DIMM air baffle, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page v and "Installation
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Grasp the DIMM air baffle and lift the baffle up, making sure that the pin
52
IBM System x3550 M3 Type 4254 and 7944: Installation and User's Guide
Cover
enclosure.
the cover and slide the cover toward the rear of the server until the cover has
disengaged from the chassis.
Attention: For proper cooling and airflow, replace the server cover before you
turn on the server.
guidelines" on page 43.
external cables if necessary.
comes out of the pin hole on the system board to the left of DIMM connector 8.
Tab