Replacing a PCI-X assembly with a PCI Express assembly
Use this information to replace a PCI-X assembly with a PCI Express assembly.
About this task
The server comes with one PCI riser-card assembly installed in slot 2. You can
replace a PCI-X riser-card assembly with a PCI Express riser-card assembly.
To replace a PCI-X riser-card assembly with a PCI Express riser-card assembly,
complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page v and "Installation
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the cover (see "Removing the cover" on page 51).
4. Remove the PCI-X riser-card assembly from the system board:
5. Install a PCI Express adapter in the PCI Express riser-card assembly. See
6. Insert the PCI Express riser-card assembly into the riser-card connector on the
Results
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 106.
74
IBM System x3550 M3 Type 4254 and 7944: Installation and User's Guide
guidelines" on page 43.
a. If an adapter is installed in the riser-card assembly, disconnect any cables
that are connected to the adapter.
b. Grasp the riser-card assembly at the rear edge and lift it from the riser-card
connector on the system board.
c. Remove the adapter, if one is present, from the riser-card assembly.
d. Store the riser-card assembly and the adapter in a safe place for possible
future use.
"Installing an adapter" on page 70 for more information. Set any jumpers or
switches on the adapter as directed by the adapter manufacturer.
Note: You might have to replace the bracket when you replace a PCI-X
assembly with a PCI Express assembly.
system board. Make sure that it is fully seated.