Updating The Server Configuration - IBM System x3550 M3 Type 4254 Installation And User Manual

Type 4254 and 7944
Hide thumbs Also See for System x3550 M3 Type 4254:
Table of Contents

Advertisement

devices to the server.

Updating the server configuration

When you start the server for the first time after you add or remove a device, you
might receive a message that the configuration has changed. The Setup utility
starts automatically so that you can save the new configuration settings.
Some optional devices have device drivers that you must install. For information
about installing device drivers, see the documentation that comes with each device.
If the server has an optional RAID adapter and you have installed or removed a
hard disk drive, see the documentation that comes with the RAID adapter for
information about reconfiguring the disk arrays.
For information about configuring the integrated Gigabit Ethernet controller, see
"Configuring the Gigabit Ethernet controller" on page 127.
110
IBM System x3550 M3 Type 4254 and 7944: Installation and User's Guide

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

System x3550 m3 type 7944

Table of Contents