Installing Drives; Installing A Hot-Swap Hard Disk Drive - IBM System x3550 M3 Type 4254 Installation And User Manual

Installing drives

The following notes describe the type of drives that the server supports and other
information that you must consider when you install a drive.
v Make sure that the devices that you are installing are supported. For a list of
v Locate the documentation that comes with the drive and follow those
v Make sure that you have all the cables and other equipment that are specified in
v Select the bay in which you want to install the drive.
v The server supports one optional ultra-slim SATA optical drive.
v Check the instructions that come with the drive to determine whether you have
v The hot-swap server models support up to eight 2.5-inch hot-swap SAS or
v The electromagnetic interference (EMI) integrity and cooling of the server are

Installing a hot-swap hard disk drive

Use this information to install a hot-swap hard disk drive.
About this task
To install a 2.5-inch hot-swap SAS or SATA hard disk drive, complete the following
steps.
Note: If you have only one hard disk drive, you must install it in the upper-left
bay.
Procedure
1. Read the safety information that begins on "Safety" on page v and "Installation
2. Remove the filler panel from the empty drive bay.
3. Touch the static-protective package that contains the drive to any unpainted
4. Install the hard disk drive in the drive bay:
62
IBM System x3550 M3 Type 4254 and 7944: Installation and User's Guide
supported optional devices for the server, see http://www.ibm.com/systems/
info/x86servers/serverproven/compat/us/.
instructions in addition to the instructions in this chapter.
the documentation that comes with the drive.
to set any switches or jumpers on the drive. If you are installing a SAS or SATA
hard disk drive, be sure to set the SAS or SATA ID for that device.
hot-swap SATA hard disk drives. The simple-swap server models support up to
four 2.5-inch simple-swap SATA hard disk drives.
protected by having all bays and PCI and PCI Express slots covered or occupied.
When you install a drive, PCI, or PCI Express adapter, save the EMC shield and
filler panel from the bay or PCI adapter or PCI Express adapter slot cover in the
event that you later remove the device.
guidelines" on page 43.
metal surface on the server; then, remove the drive from the package and place
it on a static-protective surface.
a. Make sure that the tray handle is in the open (unlocked) position.
b. Align the drive assembly with the guide rails in the bay.