Remove A Hard Disk Module; Remove A Nic Module; Remove A Nic Access Module - Juniper G10 CMTS Hardware Manual

Module Removal
•

Remove a Hard Disk Module

•
•
•
•
•
•
•
•
•
•
•
•
•
•

Remove a NIC Module

•
•
•
•
•
•
•

Remove a NIC Access Module

•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
170 JUNOSg 3.0 G10 CMTS Hardware Guide
To remove a Hard Disk Module, follow this procedure:
1. Stop the CMTS software by issuing the request system halt command:
user@host> request system halt
2. Power down the CMTS.
3. Follow the same procedure described in "Remove an HFC Connector Module or SIM" on
page 168.
The NIC Module is hot-swappable, so you can remove it or install it while the CMTS is
powered on. To remove a NIC Module, follow the same procedure described in "Remove a
DOCSIS Module" on page 166.
The NIC Access Module is hot-swappable, so you can remove it or install it while the CMTS is
powered on. To remove a NIC Access Module, follow the same procedure described in
"Remove an HFC Connector Module or SIM" on page 168.