Table of Contents
Advertisement
Table 44: NIC Access Module LED Status
Power On and Configure the PC
1.
2.
described in step 8 (see Figure 17 on page 49). Table 44 indicates the expected status of
all the LEDs on the NIC Access Module's rear panel following power-on. If the
OPERATION LED is not illuminated green, the NIC Access Module is considered faulty
and you might have to replace it (see the "Remove a NIC Access Module" on page 170).
LED
POWER
OPERATIONAL
INT FAULT
EXT FAULT
Before you replace any module that appears to be faulty
based on its LED status, contact Juniper Networks
customer support for technical assistance.
Power on the personal computer (PC) attached to the serial port of the Chassis Control
Module.
Launch your asynchronous terminal emulation application (such as Microsoft Windows
Hyperterminal), and establish a direct connection. Configure the port settings as follows:
! Bits per second: 9600
! Data bits: 8
! Parity: None
! Stop bits: 1
! Flow control: None
Post-initialization Status
Green
Green
Off
Off
Amber
Connect the Power and Perform Initial Configuration
Power On and Configure the PC
Meaning
Power is applied.
Successful initialization.
No internal failure.
No external failure.
One or more of the FE or GE ports is
enabled, but unused.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
127
Advertisement
Table of Contents
Troubleshooting
