Hdc1400/1500/1580 (Encapsulated Cable Assembly) - Sony HDC1000 Maintenance Manual

2-9-2. HDC1400/1500/1580 (Encapsulated
Cable Assembly)
1. Remove the outside panel. (Refer to Section 1-4.)
2. Remove the three screws of the SDI unit, and open it
in the arrow direction.
Outside panel
3. Remove the UL tape from the SDI-84/84C board.
4. Release the harness and cables from the three harness
clamps.
5. Disconnect the harness from the connector (CN102)
on the SDI-84/84C board.
6. Disconnect the optical fiber cables from the E/O
converter module CP201 and O/E converter module
CP401 on the SDI-84/84C board.
m
. If optical fiber cable is bent or pulled strongly, it
may be disconnected. Handle optical fiber cables
carefully.
. Do not touch the tip of optical fiber cable connector.
This may result in deterioration of signals.
Optical fiber cable (No.2)
Harness clamps
SDI-84/84C board
HDC1000/V1(E)
SDI unit
Screws of
SDI unit
Optical fiber cable (No.1)
CP401
CP201
CN102
UL tape
7. Remove the screw to detach the harness clamp and the
lug.
8. Remove the four screws, and pull out the encapsulated
cable assembly.
Lug
Outside panel
9. Install the encapsulated cable assembly by reversing
the steps above.
m
. Check cable numbers when connecting optical fiber
cables, and insert the cable connector as far as it will
go.
. Arrange the harness and cables as shown below, and
clamp them with the three harness clamps and UL
tape.
Optical fiber cable (No.2)
Coaxial cable
(black)
Harness clamps
UL tape
SDI-84/84C
board
Capacitors
. When connecting the optical fiber cables to the E/O
converter module CP201 or O/E converter module
CP401 on the SDI-84/84C board, clean the connect-
ing connectors. (Refer to Section 1-8.)
Harness clamp
B2.6 x 5
B3 x 8
Encapsulated cable assembly
CP401
Coaxial cable (white)
2
1
CN102
CP201
Optical fiber cable (No.1)
2-19