Dc In Connector (Cn-2623 Board) - Sony HDC1000 Maintenance Manual

2-8-2. DC IN Connector (CN-2623 Board)

1. Remove the four screws, and pull out the MIC panel
assembly.
2. Disconnect the flexible card wires from the connector
(CN1) on the CN-2619 board and from the connector
(CN1) on the CN-2621 board.
3. Disconnect the harnesses from the connector (CN2) on
the CN-2619 board and from the connector (CN2) on
the CN-2623 board.
4. Disconnect the coaxial cable from the SDI 2 connector
(HDC1500) or SDI connector (HDC1550), and
remove the MIC panel assembly.
n
Be sure to hold the plug when disconnecting the
coaxial cable. Do not pull the cable.
Hold the plug to
OK
remove.
CN-2621 board
CN2
CN2
CN-2623 board
HDC1000/V1(E)
Do not attempt to
NG
remove by pulling
the cable.
MIC panel assembly
CN-2619
board
CN1
CN1
Screws
(M2)
SDI 2/SDI
connector
Screws (M2)
5. Remove the two screws, and remove the CN-2623
board.
6. Unsolder the DC IN connector from the CN-2623
board.
Unsolder
7. Install a new DC IN connector by reversing the steps
above.
n
Hold the plug of the coaxial cable, and connect it
perpendicularly to the connector.
Push the plug into the connector while turning it
clockwise and counterclockwise several times.
Connecting connector
CN-2623 board
DC IN Connector
Screws
(M2)
Hold the plug to connect
2-13