Replacement Of Main Parts; Replacing The Ccd Unit; Hdc1000 - Sony HDC1000 Maintenance Manual

2-1. Replacing the CCD Unit

n
Never remove or install the CCD unit with the power
turned on. Because touching internal harness to the cabinet
or other printed circuit boards during replacement causes
short circuits or electric hazards.
Prior to replacement, be sure to disconnect the optical/
electrical cable or the cable connected to the DC IN
connector in addition to turning off power switch.

2-1-1. HDC1000

1. Loosen the screw of the mount lever fixing lid, and
open the mount lever fixing lid in the arrow direction.
2. Loosen the four screws of front assembly, and remove
the front assembly.
Front assembly
PWH4 x 10
(with stopper)
PWH4 x 10
(with stopper)
Mount lever fixing lid
HDC1000/V1(E)
Section 2

Replacement of Main Parts

3. Remove the two screws and four hexagon-socket bolts,
4. Disconnect the harness from the connector of CCD
Screw
and remove the four spring washers, and front panel
assembly.
Spring washers
B2.6 x 6
Hexagon-socket
bolts (3 x 8)
Hexagon-socket bolts
(3 x 8)
unit, loosen the two fixing screws of the filter disk
unit, and remove the filter disk unit.
Connector
Fixing screw of the
filter disk unit (with stopper)
Front panel assembly
Spring washers
Fixing screw of the
filter disk unit (with stopper)
Filter disk unit
2-1