Reference File - Sony HDC1000 Maintenance Manual

4-5. Reference File

Reference File stores data in the camera and the memory stick.
It also stores in the IC memory card if the MSU (master setup unit) is used. For the details, refer to the
MSU operation manual.
Storing and calling the data are implemented using the setup menu or MSU.
Reference Files stores the differential data taking the factory-setting as 0. Therefore, initializing the
Reference File brings the settings to the same status at factory-setting. If Lens File or OHB File retains the
data, they need to be initialized as well. To initialize data, use the setup menu. You can select whether to
initialize the all file items or only the specified items.
Reference Files can be copied between cameras using the memory stick.
n
Before storing the data in the memory stick, make sure that the LOCK switch on the memory stick is in
OFF position.
Storing (Refer to step 1 of Fig.4-4.)
Using FILE Menu of This Unit
[FILE] → [REFERENCE] → [STORE|FILE]
The data will be stored in the camera and the numerical data will be displayed as 0. (Excluding some
items. Refer to Section 4-8. "File Items".)
With MSU
Press FILE button. Then press [Reference] and press [Ref|Store]. The data will be stored in the
camera and the numerical data will be displayed as 0. (Excluding some items. Refer to Section 4-8. "File
Items".)
Calling (Refer to step 2 of Fig. 4-4, Fig. 4-1.)
Using PAINT Menu of This Unit
[PAINT] → [SCENE|FILE] → [STANDARD]
The temporary paint amount and scene file amount will be cleared and the reference file will be reset to
the state stored in.
With MSU
Press STANDARD button to reset the reference file item to the state stored in.
4-6
HDC1000/V1(E)