Replacement Of Main Parts; Replacing Ccd Unit - Sony F35 Maintenance Manual

n
Notes on handling the coaxial cable and routing the
harness are described collectively in the latter half of this
Section. Refer to Section 2-10 or 2-11, if necessary.
. Notes on Disconnecting/Connecting the Coaxial Cable
(Refer to Section 2-10. )
. Routing the Harness (Refer to Section 2-11. )

2-1. Replacing CCD Unit

1. Remove the inside panel. (Refer to Section 1-4.)
2. Remove the six screws to detach the front assembly.
3. Raise the board retainer at the rear of the CCD unit in
the direction of the arrow.
4. Disconnect the harness (CLICK) from the connector
(CN23) on the MB-1100 board, and disconnect the
harness (OHB-PS35T) from the connector (CN2) on
the BI-205 board. Disconnect the flexible board from
the connector (CN4) on the TG-258 board, and
connector (CN101) on the AD-180 board.
CN-2903 board Board retainer
Harness
(CLICK)
B3 x 8
Front assembly B3 x 8
BI-205 board
(CN2)
F35
Section 2

Replacement of Main Parts

AD-180 board
MB-1100 board
(CN101)
(CN23)
Harness
(OHB-PS35T)
TG-258 board
(CN4)
5. Remove the three hexagon socket bolts (3 x 14), the
three washers, the hexagon socket bolt (3 x 25), the
spacer, and the 11 screws (M2), and remove the CCD
unit.
Front panel sub assembly
Spacer
Hexagon
socket
bolts
Washer
(3 x 25)
Hexagon socket bolts (3 x 14)
6. Remove the 10 screws, and remove the front panel SV
from the CCD unit for repair.
CCD unit
B3 x 8
Screws (M2)
Screws (M2)
Screws (M2)
Screws (M2)
CCD unit
Screws (M2)
Screws (M2)
Screws (M2)
Front panel SV
2-1