Stapling Unit Moving Mechanism; Stapling Position - Konica Minolta bizhub c650 Service Manual

5. Operations
5.4.2

Stapling unit moving mechanism

• The stapling unit is moved by the stapling unit moving motor.
• The stapling unit moving motor drives the belt so that the stapling unit is moved to the
corresponding stapling position.
• The stapling stop position is controlled by the period of time during which the stapling
unit moving motor is kept energized, as counted from the time when the staple home
position sensor has been activated.
• The stapler unit will move to the stapler save position during the saddle mode.
(The stapler unit needs to be in the save since the moving part of the holding section
shifts from horizontal to 20 degrees angles during the saddle mode.)
• The stapler save position is detected by the stapler save position sensor.
Stapler save position
sensor (PS10)
Staple home position
sensor (PS9)
5.4.3

Stapling position

• A single stapling unit is moved to perform 2-point stapling.
<Typical stapling positions>
Parallel one point
24
Stapling unit moving
motor (M7)
Slant one point
stapling
Theory of Operation Ver. 2.0 Aug. 2007
Save position
Stapling unit
Parallel two
stapling
points
Home
position
Staple
change
position
9J08T2C013DA
stapling
4349T2C523AA